Insert second programmed key into ignition and turn ignition switch to on.
2010 dodge ram 1500 key fob reset.
Press and release the button five times within ten seconds.
Step 1 sit in your car with your remote and your key fob.
Insert the first working fobik remote key into ignition.
Hold the lock on the fob for 5 sec.
You would have to check with a dealership or a local locksmith to see if it is possible.
You must do this within 15 seconds of removing first key.
Insert new cr2032 battery.
Turn ignition switch to off and remove key.
Remove metal key from fob.
Easy peasy repair and replace no programming needed if circuit board is not damaged.
Do not exceed 15 seconds.
Insert first programmed key into ignition and turn ignition switch to on for 5 seconds.
Insert a flat edged tool like a screwdriver into the gap.
Save your self some cash.
Now put the key fob into ignition and turn to on position.
Turn vehicle off and turn hazards off unless you want to drain your battery.
But i did read a post awhile ago that said it is now possible but haven t verified it as true.
Gently remove dead ram key fob battery.
Take the following steps to replace your chrysler dodge jeep or ram key fob battery.
Enter your dodge ram 1500 and close the doors and trunk of your vehicle.
Click unlock on the fob that s in the ignition.
Turn ignition to the off position and remove key.
Step 2 insert your dodge ram 1500 key into your car s ignition and click the key to the on position.
Pry the two sections apart.
Procedure 2 ram 1500 fobik remotes step by step how to programming instructions.
Turn ignition to the on position for at least three 3 to fifteen 15 seconds.
Turn on ignition switch to on position engine off repeatedly press vechicle information button until press to relearn remote key is displayed press set reset button until remote key learning active is displayed.
Once a key fob is programmed to a vehicle it can t be reprogrammed to another vehicle.
You should hear it unlock.