Before the installation begins it is important to perform a thorough job site inspection.
How to install glue down method of wood flooring.
How to install glue down engineered wood flooring on concrete slab preparation.
Glue down hardwood floors is a good solution for large open areas where footsteps and drumming noise needs to be minimised.
This is done by introducing glue to the nailing process.
Our highly durable and secure glue down system incorporates a junckers liquid moisture barrier which is applied if necessary first to protect against higher than normal residual moisture in the subfloor.
In part 3 we will examine the pros and cons of choosing the glue down method of installation.
Quick guide on how to install hardwood floor 300kb pdf our short installation guide for those with diy experience.
The wall coverings and painting should be completed before the installation of the hardwood flooring.
If installing glue down hardwood flooring in a new house completely close the building in with all outside doors and windows in place.
Flooring selection lumber liquidators recommends engineered flooring for glue down applications or the more stable.
As you have read in part 1 part 2 there are multiple methods of installing hardwood flooring both engineered and solid.
Use this method for solid t g hardwood above wood or concrete subfloors.
Slab preparation is critical for glue down and includes sanding scraping leveling and filling low spots because the slab must be flat so the planks can fit correctly.
Installing hardwood flooring glue down method step by step instructions.
This is recommended on all wide plank solid and engineered floors 5 and wider installed on a plywood or osb subfloor.
Helpful tips for glue down installations.
After making sure the surface is completely level and clean place the substrate sheets on the ground and stretch them out properly.
From start to finish learn how to install a beautiful new wood floor properly and easily using the glue down method with floor decor s installation guide.
The installation method recommended is not a full glue down installation but only a bead of glue across the width of the board.