Tongue and groove chipboard is a type of particle board made up of sawdust and resin.
How to lay tongue and groove chipboard flooring.
Your sub floor joists should be at 400mm centres meaning the edge of the boards always falls on a joist too.
Standard size sheets are 2400mm x 600mm and available in two thicknesses 18mm and 22mm.
The tongue and groove edges make for a strong bond between the boards.
How to lay a t g chipboard floor.
To get your join really tight it helps to knock the boards into place with a sledgehammer.
Once this has been done add a bead of adhesive to the tongue and groove joint on top of the screw and push the adjacent panels together using the tongue and groove connection.
It s often used as an underlayment for wood tile and sheet flooring.
They are relatively cheap and quick to lay.
Continue to lay chipboard flooring across the joists for the rest of the floor ensuring the joints along the 600mm edges are staggered always avoid joining on the same joist wherever possible.
Chipboard is a form of particleboard which means it s pieces of wood and other materials that are pressed together with glue to form the boards.
To protect the edge of your board put a piece of scrap timber in front of it and swing the hammer into that.
Tighten joins in chipboard flooring.
Then lay a chipboard flooring panel down adding a screw to the tongue at each tongue and groove joint to secure it to the joist below.
Chipboard flooring panels are joined together using a tongue and groove system.
Tongue and groove chipboard is made to fit tightly together to form a solid floor base.