When loading a cutting mat into your silhouette align the mat with the white rollers.
How to load cutting mat silhouette cameo 2.
The mat was feeding initially but then would start slanting and feeding totally wrong and end up at.
Start by gently positioning the top edge of the silhouette cutting mat along the white rollers.
Now select load on your cameo 3.
To load the cutting mat into the silhouette machine.
How to load vinyl without a mat.
Next butt the mat up to the rollers on your machine.
Within the send panel select your material type.
Use the grid lines on the mat to line the material up with the edges of the sticky portion of your mat.
The left edge of the mat should be aligned with the line and two arrows.
To load a cutting mat into the silhouette cameo remove the protective covering sheet from the mat.
Line the mat up with the blue line on the left hand side of your machine.
Cutting with a cutting mat.
Send it to cut.
In order to prevent damage to your cutting strip a mat should always be used when cutting materials without a backing i would rather take the time to load my mat than have to replace the cutting strip on my machine.
I like to cut most of my vinyl without a mat because the majority of the time i am using rolls of vinyl instead of.
If the vinyl doesn t load straight unload and reload until it does.
Your machine will roll your mat into the cutting area.
Load options for the original cameo cameo 2 and portrait are selected using the buttons on the machine itself.
Make sure the arrow on the top of the mat is pointing into the machine.
Hey guys forgot to mention i have put together a playlist of all my cameo updates so far on my channel to make it easier to find with them all grouped togeth.
Place your material on your mat to correspond with the display in silhouette studio before cutting.
I just got off the phone with silhouette and had to edit this post after getting some great help.
Paper and similar stiff materials that usually need a mat to cut completely through should use pop out cut when you have no mat selected in the page setup panel.
So something i learned rather quickly after ruining 2 pieces of cardstock on my new silhouette cameo.
If you have a cameo 3 click load on the panel to load the vinyl into the machine.
Press load from the control panel on the front of the machine.
Place the vinyl on the correct size of mat you have selected in the silhouette software.
Next apply your material to the mat.
If you have a cameo 1 or 2 select load media from the panel.
Use the blue line on the left hand side of your machine as a guide to align your mat.